Article 8

Before producing and placing on the market products referred to in Article 1 (1), the manufacturer or his authorized representative established in the Community shall apply the following procedures for boat design categories A, B, C and D as referred to in Section 1 of Annex I. 1. For categories A and B: for boats of less than 12 m hull length: the internal production control plus tests (module Aa) referred to in Annex VI, for boats from 12 m to 24 m hull length: the EC type-examination (module B) referred to in Annex VII supplemented by module C (type conformity) referred to in Annex VIII, or any of the following modules: B + D, or B + F, or G or H. 2. For category C: for boats from 2,5 m to 12 m hull length: where the harmonized standards relating to sections 3.2 and 3.3 of Annex I are complied with: the internal production control (module A), referred to in Annex V, where the harmonized standards relating Sections 3.2 and 3.3 of Annex I are not complied with: the internal production control plus tests (module Aa) referred to in Annex VI. for boats from 12 m to 24 m hull length: the EC type-examination (module B) referred to in Annex VII followed by module C (type conformity) referred to in Annex VIII, or any of the following modules: B + D, or B + F, or G or H. 3. For category D: For boats from 2,5 m to 24 m hull length: the internal production control (module A) referred to in Annex V. 4. For components referred to in Annex II: any of the following modules: B + C, or B + D, or B + F, or G or H.

← 4. · All articles · art_8__para →

Source: EUR-Lex (Cellar) · retrieved 2026-11-02 · Text as adopted (Official Journal); later amendments are not incorporated in this text.