1.1. Deteriorated components/systems

Commission Directive 2005/78/EC of 14 November 2005 implementing Directive 2005/55/EC of the European Parliament and of the Council on the approximation of the laws of the Member States relating to the measures to be taken against the emission of gaseous and particulate pollutants from compression-ignition engines for use in vehicles, and the emission of gaseous pollutants from positive ignition engines fuelled with natural gas or liquefied petroleum gas for use in vehicles and amending Annexes I, II, III, IV and VI thereto (Text with EEA relevance) · European Union

In order to demonstrate the efficient monitoring of an emission control system or component, the failure of which may result in tailpipe emissions exceeding the appropriate OBD threshold limits, the manufacturer must make available the deteriorated components and/or electrical devices which would be used to simulate failures. Such deteriorated components or devices must not cause emissions to exceed the OBD threshold limits referred to in the table in Article 4(3) of this Directive by more than 20 %. In the case of type-approval of an OBD system according to Article 4(1) of this Directive, the emissions shall be measured over the ESC test cycle (see Appendix 1 to Annex III to Directive 2005/55/EC). In the case of type-approval of an OBD system according to Article 4(2) of this Directive, the emissions shall be measured over the ETC test cycle (see Appendix 2 to Annex III to Directive 2005/55/EC). 1.1.1. If it is determined that the installation of a deteriorated component or device on an engine means that a comparison with the OBD threshold limits is not possible (e.g. because the statistical conditions for validating the ETC test cycle are not met), the failure of that component or device may be considered as qualified upon the agreement of the type-approval authority based on technical argumentation provided by the manufacturer. 1.1.2. In the case that the installation of a deteriorated component or device on an engine means that the full load curve (as determined with a correctly operating engine) cannot (even partially) be attained during the test, the deteriorated component or device is considered as qualified upon the agreement of the type-approval authority based on technical argumentation provided by the manufacturer. 1.1.3. The use of deteriorated components or devices that cause engine emissions to exceed the OBD threshold limits referred to in the table in Article 4(3) of this Directive by no more than 20 % may not be required in some very specific cases (for example, if a limp home strategy is activated, if the engine cannot run any test, or in case of EGR sticking valves, etc). This exception shall be documented by the manufacturer. It is subject to the agreement of the technical service.

← sec_1__4__para · All articles · sec_1_1__para →

Source: EUR-Lex (Cellar) · retrieved 2026-11-10 · Text as adopted (Official Journal); later amendments are not incorporated in this text.