ANNEX XI
1.1. This Annex sets out the functional aspects of on-board diagnostic (OBD) systems for the control of emissions from motor vehicles. 2.1. The requirements and tests for OBD systems are those specified in Section 3 of Annex 11 to UN/ECE Regulation 83. The exceptions to these requirements as well as additional requirements are described in the following sections. 2.2. The durability distance mentioned in section 3.1 and 3.3.1 of Annex 11 to UN/ECE Regulation 83 shall be understood as reference to the requirements of Annex VII to this Regulation. The threshold limits specified in section 3.3.2 of Annex 11 to UN/ECE Regulation 83 shall be understood as reference to the tables below: 2.3.1. The OBD thresholds limits for vehicles that are type approved according to the emission limits set out in Table 1 of Annex I of the Regulation (EC) No 715/2007 are contained in the following table. Euro 5 OBD threshold limits | Reference mass (RW) (kg) | Mass of carbon monoxide | Mass of non-methane hydrocarbons | Mass of oxides of nitrogen | Mass of particulates (CO) (mg/km) | (NMHC) (mg/km) | (NOx) (mg/km) | (PM) (mg/km) Category | Class | | PI | CI | PI | CI | PI | CI | PI (1) | CI (2) M | — | All | 1 900 | 1 900 | 250 | 320 | 300 | 540 | 50 | 50 N1 (3) | I | RW ≤ 1 305 | 1 900 | 1 900 | 250 | 320 | 300 | 540 | 50 | 50 II | 1 305 < RW ≤ 1 760 | 3 400 | 2 400 | 330 | 360 | 375 | 705 | 50 | 50 III | 1 760 < RW | 4 300 | 2 800 | 400 | 400 | 410 | 840 | 50 | 50 N2 | — | All | 4 300 | 2 800 | 400 | 400 | 410 | 840 | 50 | 50 Key: PI = Positive Ignition, CI = Compression Ignition 2.3.2. The OBD thresholds limits for compression ignition vehicles that comply with the Euro 6 emission limit values set out in Table 2 of Annex 1 of the Regulation (EC) No 715/2007 and type-approved before the dates given in Article 10(4) of Regulation (EC) No 715/2007 are contained in the following table. These threshold limits shall cease to apply from the dates set out in Article 10(5) of Regulation (EC) No 715/2007 for new vehicles to be registered, sold or entered into service. Interim Euro 6 OBD threshold limits | Reference mass (RW) (kg) | Mass of carbon monoxide | Mass of non-methane hydrocarbons | Mass of oxides of nitrogen | Mass of particulates (CO) (mg/km) | (NMHC) (mg/km) | (NOx) (mg/km) | (PM) (mg/km) Category | Class | | CI | CI | CI | CI M | — | All | 1900 | 320 | 240 | 50 N1 | I | RW ≤ 1 305 | 1900 | 320 | 240 | 50 II | 1 305 < RW ≤ 1 760 | 2 400 | 360 | 315 | 50 III | 1 760 < RW | 2 800 | 400 | 375 | 50 N2 | — | All | 2 800 | 400 | 375 | 50 Key: CI = Compression Ignition 2.4. In addition to the provisions of section 3.2.1 of Annex 11 to UN/ECE Regulation 83 the manufacturer may temporarily disable the OBD system in the following conditions: For flex fuel or mono/bi fuel gas vehicles during 1 minute after re-fuelling to allow for the recognition of fuel quality and composition by the ECU; For bi fuel vehicles during 5 seconds after fuel switching to allow for readjusting engine parameters. The manufacturer may deviate from these time limits if it can demonstrate that stabilisation of the fuelling system after re-fuelling or fuel switching takes longer for justified technical reasons. In any case, the OBD system shall be re-enabled as soon as either the fuel quality and composition is recognised or the engine parameters are readjusted. 2.5. Section 3.3.3.1 of Annex 11 to UN/ECE Regulation 83 shall be replaced by the following requirement: The OBD system shall monitor the reduction in the efficiency of the catalytic converter with respect to emissions of THC and NOx. Manufacturers may monitor the front catalyst alone or in combination with the next catalyst(s) downstream. Each monitored catalyst or catalyst combination shall be considered malfunctioning when the emissions exceed the NMHC or NOx threshold limits provided for by section 2.3 of this Annex. By way of derogation the requirement of monitoring the reduction in the efficiency of the catalytic converter with respect to NOx emissions shall only apply as from the dates set out in Article 17. 2.6. Section 3.3.3.3 of Annex 11 to UN/ECE Regulation 83 shall mean that the deterioration of all oxygen sensors fitted and used for monitoring malfunctions of the catalytic converter according to the requirements of this Annex shall be monitored. 2.7. In addition to the requirements of section 3.3.3 of Annex 11 to UN/ECE Regulation 83, for direct injection positive ignition engines any malfunction, which may lead to emissions exceeding the particulate threshold limits provided for by section 2.3 of this Annex and which has to be monitored according to the requirements of this Annex for compression ignition engines, shall be monitored. 2.8. In addition to the requirements of section 3.3.4 of Annex 11 to UN/ECE Regulation 83, malfunctions and the reduction in efficiency of the EGR system shall be monitored. 2.9. In addition to the requirements of section 3.3.4 of Annex 11 to UN/ECE Regulation 83, malfunctions and the reduction in efficiency of a NOx aftertreatment system using a reagent and the reagent dosing sub-system shall be monitored. 2.10. In addition to the requirements of section 3.3.4 of Annex 11 to UN/ECE Regulation 83, malfunctions and the reduction in efficiency of NOx aftertreatment not using a reagent shall be monitored. 2.11. In addition to the requirements of section 6.3.2 of Appendix 1 to Annex 11 to UN/ECE Regulation 83, the manufacturer shall demonstrate that malfunctions of the EGR flow and cooler are detected by the OBD system during its approval test. 2.12. References to ‘HC’ (hydrocarbons) shall be read as ‘NMHC’ (non-methane hydrocarbons) in section 6.4.1.2 of Appendix 1 to Annex 11 to UN/ECE Regulation 83. 2.13. In addition to the requirements of section 6.5.1.3 of Appendix 1 to Annex 11 of UN/ECE Regulation 83, all data required to be stored in relation to OBD in-use performance according to the provisions of section 3.6 of Appendix 1 of this Annex shall be available through the serial data port on the standardised data link connector according to the specifications given in section 6.5.3 of Appendix 1 to Annex 11 of UN/ECE Regulation 83. 3.1. In considering the request for granting type-approval to a vehicle with a deficiency or deficiencies as set out in Article 6(2), the approval authority shall determine whether compliance with the requirements of this Annex is infeasible or unreasonable. 3.2. The approval authority shall take into consideration data from the manufacturer that details such factors as, but not limited to, technical feasibility, lead time and production cycles including phase-in or phase-out of engines or vehicle designs and programmed upgrades of computers, the extent to which the resultant OBD system will be effective in complying with the requirements of this Regulation and that the manufacturer has demonstrated an acceptable level of effort toward compliance with the requirements of this Regulation. 3.3. The approval authority will not accept any deficiency request that includes the complete lack of a required diagnostic monitor. 3.4. The approval authority will not accept any deficiency request that does not respect the OBD threshold limits in Section 2.3. 3.5. In determining the identified order of deficiencies, deficiencies relating to sections 3.3.3.1, 3.3.3.2 and 3.3.3.3 of Annex 11 of UN/ECE Regulation 83 for positive-ignition engines and sections 3.3.4.1, 3.3.4.2 and 3.3.4.3 of Annex 11 of UN/ECE Regulation 83 for compression-ignition engines shall be identified first. 3.6. Prior to or at the time of type-approval, no deficiency shall be granted in respect of the requirements of section 6.5, except section 6.5.3.4 of Appendix 1 to Annex 11 of UN/ECE Regulation 83. 3.6.1. A deficiency may be carried-over for a period of two years after the date of type-approval of the vehicle type unless it can be adequately demonstrated that substantial vehicle hardware modifications and additional lead-time beyond two years would be necessary to correct the deficiency. In such a case, the deficiency may be carried-over for a period not exceeding three years. 3.6.2. A manufacturer may request that the approval authority grant a deficiency retrospectively when such a deficiency is discovered after the original type-approval. In this case, the deficiency may be carried-over for a period of two years after the date of notification to the approval authority unless it can be adequately demonstrated that substantial vehicle hardware modifications and additional lead-time beyond two years would be necessary to correct the deficiency. In such a case, the deficiency may be carried-over for a period not exceeding three years. 3.7. The approval authority shall notify its decision in granting a deficiency request in accordance with Article 6(2). 4.1. Requirements for access to OBD information are specified in section 5 of Annex 11 to UN/ECE Regulation 83. The exceptions to these requirements are described in the following sections. 4.2. References to Appendix 1 of Annex 2 to UN/ECE Regulation 83 shall be understood as references to Appendix 5 to Annex I to this Regulation. 4.3. References to section 4.2.11.2.7.6 of Annex 1 to UN/ECE Regulation 83 shall be understood as references to 3.2.12.2.7.6 of Appendix 3 to Annex I to this Regulation. 4.4. References to ‘contracting parties’ shall be understood as references to ‘member states’. 4.5. References to approval granted under Regulation 83 shall be understood as references to type-approval granted under this Regulation and Council Directive 70/220/EEC (1). 4.6. UN/ECE type-approval shall be understood as EC type-approval.
← anx_X__para__3 · All articles · ON-BOARD DIAGNOSTICS (OBD) FOR MOTOR VEHICLES →
Source: EUR-Lex (Cellar) · retrieved 2026-11-20 · Text as adopted (Official Journal); later amendments are not incorporated in this text.