STATISTICAL PROCEDURE FOR IN-SERVICE CONFORMITY TESTING
1. This procedure shall be used to verify the in-service conformity requirements for the type 1 test. The applicable statistical method set out in Appendix 4 to UN/ECE Regulation No 83 shall apply, with the exceptions described in the sections 2 to 9. 2. Footnote 1 shall not apply. 3. Paragraphs 3.2 shall be understood as follows: A vehicle is said to be an outlying emitter when the conditions given in paragraph 3.2.2 are met. 4. Paragraph 3.2.1 shall not apply. 5. In paragraph 3.2.2 the reference to row B of the table in paragraph 5.3.1.4 shall be understood as reference to Table 1 of Annex I to Regulation (EC) No 715/2007 for Euro 5 vehicles and to Table 2 of Annex I to Regulation (EC) No 715/2007’for Euro 6 vehicles. 6. In paragraphs 3.2.3.2.1 and 3.2.4.2 the reference to paragraph 6 of Appendix 3 shall be understood as reference to Section 6 of Appendix 1 to Annex II to this Regulation. 7. In footnotes 2 and 3 the reference to row A of the table in paragraph 5.3.1.4 shall be understood as reference to Table 1 of Annex I to Regulation (EC) No 715/2007 for Euro 5 vehicles and to Table 2 of Annex I to Regulation (EC) No 715/2007 for Euro 6 vehicles. 8. In paragraph 4.2. the reference to paragraph 5.3.1.4 shall be understood as reference to Table 1 of Annex I to Regulation (EC) No 715/2007 for Euro 5 vehicles and Table 2 of Annex I to Regulation (EC) No 715/2007 for Euro 6 vehicles. 9. Figure 4/1 shall be replaced by the following figure:
← Appendix 2 · All articles · doc__heading__16__para →
Source: EUR-Lex (Cellar) · retrieved 2026-11-20 · Text as adopted (Official Journal); later amendments are not incorporated in this text.