3.1. General Requirements
3.1.1. Each monitor of the OBD system shall be executed at least once per driving cycle in which the monitoring conditions as specified in section 3.2 are met. Manufacturers may not use the calculated ratio (or any element thereof) or any other indication of monitor frequency as a monitoring condition for any monitor. 3.1.2. The in-use performance ratio (IUPR) of a specific monitor M of the OBD system referred to in Article 5(3) shall be: IUPRM = NumeratorM/DenominatorM 3.1.3. Comparison of Numerator and Denominator gives an indication of how often a specific monitor is operating relative to vehicle operation. To ensure all manufacturers are tracking IUPRM in the same manner, detailed requirements are given for defining and incrementing these counters. 3.1.4. If, according to the requirements of this Annex, the vehicle is equipped with a specific monitor M, IUPRM shall be greater or equal to the following minimum values: 0,260 for secondary air system monitors and other cold start related monitors 0,520 for evaporative emission purge control monitors 0,336 for all other monitors 3.1.5. Vehicles shall comply with the requirements of section 3.1.4 for a mileage of at least 160 000 km. By way of derogation, vehicles type approved, registered, sold or entered into service before the relevant dates given in Article 10(4), (5) of Regulation (EC) No 715/2007, shall have an IUPRM greater or equal 0,1 for all monitors M. 3.1.6. The requirements of this section are deemed to be met for a particular monitor M, if for all vehicles of a particular OBD family manufactured in a particular calendar year the following statistical conditions hold: The average IUPRM is equal or above the minimum value applicable to the monitor More than 50 % of all vehicles have an IUPRM equal or above the minimum value applicable to the monitor. 3.1.7. The manufacturer shall demonstrate to the approval authority and on request to the Commission that these statistical conditions are satisfied for vehicles manufactured in a given calendar year for all monitors required to be reported by the OBD system according to section 3.6 of this Appendix not later than 18 months after the end of a calendar year. For this purpose, statistical tests shall be used which implement recognised statistical principles and confidence levels. 3.1.8. For demonstration purposes of this section the manufacturer may group vehicles within an OBD family by any other successive and non-overlapping 12 month manufacturing periods instead of calendar years. For establishing the test sample of vehicles at least the selection criteria of Annex II, Appendix 1, point 2 shall be applied. For the entire test sample of vehicles the manufacturer must report to the approval authority all of the in-use performance data to be reported by the OBD system according to section 3.6 of this Appendix. Upon request, the approval authority which grants the approval shall make these data and the results of the statistical evaluation available to the Commission and other approval authorities. 3.1.9. Public authorities and their delegates may pursue further tests on vehicles or collect appropriate data recorded by vehicles to verify compliance with the requirements of this Annex.
← 3. IN-USE PERFORMANCE · All articles · sec_3_1__3__para →
Source: EUR-Lex (Cellar) · retrieved 2026-11-20 · Text as adopted (Official Journal); later amendments are not incorporated in this text.