4.
Information to be provided by manufacturers For the purposes of conformity assessment pursuant to Article 4, the technical documentation shall contain the following elements: for each standby and/or off mode: the power consumption data in Watts rounded to the second decimal place, the measurement method used, description of how the appliance mode was selected or programmed, sequence of events to reach the mode where the equipment automatically changes modes, any notes regarding the operation of the equipment; test parameters for measurements: ambient temperature, test voltage in V and frequency in Hz, total harmonic distortion of the electricity supply system, information and documentation on the instrumentation, set-up and circuits used for electrical testing; the characteristics of equipment relevant for assessing conformity with the requirements set out in point 1(c), or the requirements set out in points 2(c) and/or 2(d), as applicable, including the time taken to automatically reach standby, or off mode, or another condition which does not exceed the applicable power consumption requirements for off mode and/or standby mode. In particular, if applicable, the technical justification shall be provided that the requirements set out in point 1(c), or the requirements set out in points 2(c) and/or 2(d), are inappropriate for the intended use of equipment.
← anx_II__cpt_1__point_3__text_3 · All articles · anx_II__cpt_1__point_4__text_1 →
Source: EUR-Lex (Cellar) · retrieved 2026-11-19 · Text as adopted (Official Journal); later amendments are not incorporated in this text.