1.

All emission limit values shall be calculated at a temperature of 273,15 K, a pressure of 101,3 kPa and after correcting for the water vapour content of the waste gases. They are standardised at 11 % oxygen in waste gas except in case of incineration of mineral waste oil as defined in point 3 of Article 3 of Directive 2008/98/EC, when they are standardised at 3 % oxygen, and in the cases referred to in Point 2.7 of Part 6. 1.1. | Daily average emission limit values for the following polluting substances (mg/Nm3) Total dust 10 Gaseous and vaporous organic substances, expressed as total organic carbon (TOC) 10 Hydrogen chloride (HCl) 10 Hydrogen fluoride (HF) 1 Sulphur dioxide (SO2) 50 Nitrogen monoxide (NO) and nitrogen dioxide (NO2), expressed as NO2 for existing waste incineration plants with a nominal capacity exceeding 6 tonnes per hour or new waste incineration plants 200 Nitrogen monoxide (NO) and nitrogen dioxide (NO2), expressed as NO2 for existing waste incineration plants with a nominal capacity of 6 tonnes per hour or less 400 1.2. | Half-hourly average emission limit values for the following polluting substances (mg/Nm3) (100 %) A (97 %) B Total dust 30 10 Gaseous and vaporous organic substances, expressed as total organic carbon (TOC) 20 10 Hydrogen chloride (HCl) 60 10 Hydrogen fluoride (HF) 4 2 Sulphur dioxide (SO2) 200 50 Nitrogen monoxide (NO) and nitrogen dioxide (NO2), expressed as NO2 for existing waste incineration plants with a nominal capacity exceeding 6 tonnes per hour or new waste incineration plants 400 200 1.3. | Average emission limit values (mg/Nm3) for the following heavy metals over a sampling period of a minimum of 30 minutes and a maximum of 8 hours Cadmium and its compounds, expressed as cadmium (Cd) Total: 0,05 Thallium and its compounds, expressed as thallium (Tl) Mercury and its compounds, expressed as mercury (Hg) 0,05 Antimony and its compounds, expressed as antimony (Sb) Total: 0,5 Arsenic and its compounds, expressed as arsenic (As) Lead and its compounds, expressed as lead (Pb) Chromium and its compounds, expressed as chromium (Cr) Cobalt and its compounds, expressed as cobalt (Co) Copper and its compounds, expressed as copper (Cu) Manganese and its compounds, expressed as manganese (Mn) Nickel and its compounds, expressed as nickel (Ni) Vanadium and its compounds, expressed as vanadium (V) These average values cover also the gaseous and the vapour forms of the relevant heavy metal emissions as well as their compounds. 1.4. | Average emission limit value (ng/Nm3) for dioxins and furans over a sampling period of a minimum of 6 hours and a maximum of 8 hours. The emission limit value refers to the total concentration of dioxins and furans calculated in accordance with Part 2. Dioxins and furans 0,1 1.5. | Emission limit values (mg/Nm3) for carbon monoxide (CO) in the waste gases: (a) 50 as daily average value; (b) 100 as half-hourly average value; (c) 150 as 10-minute average value. The competent authority may authorise exemptions from the emission limit values set out in this point for waste incineration plants using fluidised bed technology, provided that the permit sets an emission limit value for carbon monoxide (CO) of not more than 100 mg/Nm3 as an hourly average value.

← anx_VI__para__8 · All articles · anx_VI__point_1__table →

Source: EUR-Lex CELLAR · retrieved 2026-08-09 · Text as consolidated on 2024-08-04; changes after this date are not shown.