2.

Special provisions for cement kilns co-incinerating waste 2.1. | The emission limit values set out in points 2.2 and 2.3 apply as daily average values for total dust, HCl, HF, NOx, SO2 and TOC (for continuous measurements), as average values over the sampling period of a minimum of 30 minutes and a maximum of 8 hours for heavy metals and as average values over the sampling period of a minimum of 6 hours and a maximum of 8 hours for dioxins and furans. All values are standardised at 10 % oxygen. Half-hourly average values shall only be needed in view of calculating the daily average values. 2.2. | C – total emission limit values (mg/Nm3 except for dioxins and furans) for the following –polluting substances Polluting substance C Total dust 30 HCl 10 HF 1 NOx 500 (1) Cd + Tl 0,05 Hg 0,05 Sb + As + Pb + Cr + Co + Cu + Mn + Ni + V 0,5 Dioxins and furans (ng/Nm3) 0,1 (1) Until 1 January 2016, the competent authority may authorise exemptions from the limit value for NOx for Lepol kilns and long rotary kilns provided that the permit sets a total emission limit value for NOx of not more than 800 mg/Nm3. 2.3. | C – total emission limit values (mg/Nm3) for SO2 and TOC Pollutant C SO2 50 TOC 10 The competent authority may grant derogations for emission limit values set out in this point in cases where TOC and SO2 do not result from the co-incineration of waste. 2.4. | C- total emission limit values for CO The competent authority may set emission limit values for CO.

← anx_VI__point_1__2__table__5 · All articles · anx_VI__point_2__2__table →

Source: EUR-Lex CELLAR · retrieved 2026-08-09 · Text as consolidated on 2024-08-04; changes after this date are not shown.