3.

Special provisions for combustion plants co-incinerating waste 3.1. | Cproc expressed as daily average values (mg/Nm3) valid until the date set out in Article 82(5) For determining the total rated thermal input of the combustion plants, the aggregation rules as defined in Article 29 shall apply. Half-hourly average values shall only be needed in view of calculating the daily average values. Cproc for solid fuels with the exception of biomass (O2 content 6 %): Polluting substances < 50 MWth 50-100 MWth 100 to 300 MWth > 300 MWth SO2 — 850 200 200 NOx — 400 200 200 Dust 50 50 30 30 Cproc for biomass (O2 content 6 %): Polluting substances < 50 MWth 50 to 100 MWth 100 to 300 MWth > 300 MWth SO2 — 200 200 200 NOx — 350 300 200 Dust 50 50 30 30 Cproc for liquid fuels (O2 content 3 %): Polluting substances < 50 MWth 50 to 100 MWth 100 to 300 MWth > 300 MWth SO2 — 850 400 to 200 (linear decrease from 100 to 300 MWth) 200 NOx — 400 200 200 Dust 50 50 30 30 3.2. | Cproc expressed as daily average values (mg/Nm3) valid from the date set out in Article 82(6) For determining the total rated thermal input of the combustion plants, the aggregation rules as defined in Article 29 shall apply. Half-hourly average values shall only be needed in view of calculating the daily average values. 3.2.1. Cproc for combustion plants referred to in Article 30(2), with the exception of gas turbines and gas engines Cproc for solid fuels with the exception of biomass (O2 content 6 %): Polluting substance < 50 MWth 50-100 MWth 100 to 300 MWth > 300 MWth SO2 — 400 for peat: 300 200 200 NOx — 300 for pulverised lignite: 400 200 200 Dust 50 30 25 for peat: 20 20 Cproc for biomass (O2 content 6 %): Polluting substance < 50 MWth 50 to 100 MWth 100 to 300 MWth > 300 MWth SO2 — 200 200 200 NOx — 300 250 200 Dust 50 30 20 20 Cproc for liquid fuels (O2 content 3 %): Polluting substance < 50 MWth 50 to 100 MWth 100 to 300 MWth > 300 MWth SO2 — 350 250 200 NOx — 400 200 150 Dust 50 30 25 20 3.2.2. Cproc for combustion plants referred to in Article 30(3), with the exception of gas turbines and gas engines Cproc for solid fuels with the exception of biomass (O2 content 6 %): Polluting substance < 50 MWth 50-100 MWth 100 to 300 MWth > 300 MWth SO2 — 400 for peat: 300 200 for peat: 300, except in the case of fluidised bed combustion: 250 150 for circulating or pressurised fluidised bed combustion or, in case of peat firing, for all fluidised bed combustion: 200 NOx — 300 for peat: 250 200 150 for pulverised lignite combustion: 200 Dust 50 20 20 10 for peat: 20 Cproc for biomass (O2 content 6 %): Polluting substance < 50 MWth 50 to 100 MWth 100 to 300 MWth > 300 MWth SO2 — 200 200 150 NOx — 250 200 150 Dust 50 20 20 20 Cproc for liquid fuels (O2 content 3 %): Polluting substance < 50 MWth 50 to 100 MWth 100 to 300 MWth > 300 MWth SO2 — 350 200 150 NOx — 300 150 100 Dust 50 20 20 10 3.3. | C — total emission limit values for heavy metals (mg/Nm3) expressed as average values over the sampling period of a minimum of 30 minutes and a maximum of 8 hours (O2 content 6 % for solid fuels and 3 % for liquid fuels) Polluting substances C Cd + Tl 0,05 Hg 0,05 Sb + As + Pb + Cr + Co + Cu + Mn + Ni + V 0,5 3.4. | C — total emission limit value (ng/Nm3) for dioxins and furans expressed as average value measured over the sampling period of a minimum of 6 hours and a maximum of 8 hours (O2 content 6 % for solid fuels and 3 % for liquid fuels) Polluting substance C Dioxins and furans 0,1

← anx_VI__point_2__2__table__4 · All articles · anx_VI__point_3__2__table →

Source: EUR-Lex CELLAR · retrieved 2026-08-09 · Text as consolidated on 2024-08-04; changes after this date are not shown.