2. TEST PROCEDURE

Commission Regulation (EU) No 1003/2010 of 8 November 2010 concerning type-approval requirements for the space for mounting and the fixing of rear registration plates on motor vehicles and their trailers and implementing Regulation (EC) No 661/2009 of the European Parliament and of the Council concerning type-approval requirements for the general safety of motor vehicles, their trailers and systems, components and separate technical units intended therefor Text with EEA relevance · European Union

The vehicle is placed on a smooth ground surface with the vehicle's mass adjusted to that of the manufacturer's declared mass in running order, but without the driver, before the measurements are made. If the vehicle is equipped with hydropneumatic, hydraulic or pneumatic suspension or a device for automatic levelling according to load, it shall be tested with the suspension or device in the normal running condition, as specified by the manufacturer. If the registration plate is facing downwards, the measurement result concerning the inclination is expressed in minus. 2.2. Projection measurements shall be made perpendicularly and directly towards the nominal surface to be covered by the registration plate. 2.3. Measurement of the space between the edge of the mounted and fixed registration plate and the actual surface shall be made perpendicularly and directly towards the actual surface to be covered by the registration plate. 2.4. The registration plate used for checking conformity shall have one of the two sizes as specified in paragraph 1.1.1.

← anx_II__cpt_1__cpt_1__cpt_2__item_3__text_1 · All articles · 2.1. Determination of the vertical inclination and height of the registration plate from the ground surface →

Source: EUR-Lex (Cellar) · retrieved 2026-11-05 · Text as adopted (Official Journal); later amendments are not incorporated in this text.