2. MASSES AND DIMENSIONS Where there is one version with a normal cab and another with a sleeper cab, both sets of masses and dimensions are to be stated. Standard ISO 612: 1978 — Road vehicles — Dimensions of motor vehicles and towed vehicles — terms and definitions. — Commission Regulation (EU) No 458/2011 of 12 May 2011 concerning type-approval…

2. MASSES AND DIMENSIONS Where there is one version with a normal cab and another with a sleeper cab, both sets of masses and dimensions are to be stated. Standard ISO 612: 1978 — Road vehicles — Dimensions of motor vehicles and towed vehicles — terms and definitions.

Commission Regulation (EU) No 458/2011 of 12 May 2011 concerning type-approval requirements for motor vehicles and their trailers with regard to the installation of their tyres and implementing Regulation (EC) No 661/2009 of the European Parliament and of the Council concerning type-approval requirements for the general safety of motor vehicles, their trailers and systems, components and separate technical units intended therefor Text with EEA relevance · European Union

2.3.1. Track of each steered axle Term No 6.5. : … 2.3.2. Track of all other axles Term No 6.5. : … 2.3.3. Width of the widest rear axle: … 2.3.4. Width of the foremost axle (measured at the outermost part of the tyres excluding the bulging of the tyres close to the ground): … 2.8. Technically permissible maximum laden mass stated by the manufacturer For trailers or semi-trailers, and for vehicles coupled with a trailer or a semi-trailer, which exert a significant vertical load on the coupling device or the fifth wheel, this load, divided by standard acceleration of gravity, is included in the maximum technically permissible mass. Please fill in here the upper and lower values for each variant. : … 2.9. Technically permissible maximum mass on each axle: … 2.11.5. Vehicle is/is not Delete where not applicable. suitable for towing loads 4.7. Maximum vehicle design speed (in km/h) With respect to motor vehicles, if the vehicle manufacturer permits that certain controller functions are modified (e.g. by means of software, hardware, upgrading, selection, enabling, disabling) before or after the vehicle has been put into service, resulting in the vehicle having an increased maximum speed, the maximum possible speed achievable by means of adjustment of these controller functions is declared. With respect to trailers, the maximum speed as permitted by the vehicle manufacturer is declared. : …

← anx_I__cpt_1__cpt_1__cpt_1__cpt_2__cpt_2__cpt_3__text_2 · All articles · 2.3. Axle track(s) and width(s) →

Source: EUR-Lex (Cellar) · retrieved 2026-11-06 · Text as adopted (Official Journal); later amendments are not incorporated in this text.