doc__table__2

Annex I | General definitions, criteria for vehicle categorisation, types of vehicle and types of bodywork Appendix 1: | Procedure for checking whether a vehicle can be categorised as off-road vehicle Appendix 2: | Digits used to supplement the codes to be used for various kinds of bodywork Annex II | Requirements for the purpose of EU type-approval of vehicles, systems, components or separate technical units Part I | Regulatory acts for EU type-approval of vehicles produced in unlimited series Appendix 1: | Regulatory acts for EU type-approval of vehicles produced in small series pursuant to Article 41 Appendix 2: | Requirements for EU individual vehicle approval pursuant to Article 44 Part II | List of UN Regulations recognised as an alternative to the Directives or Regulations referred to in Part I Part III | List of regulatory acts setting out the requirements for the purpose of EU type-approval of special purpose vehicles Appendix 1: | Motor-caravans, ambulances and hearses Appendix 2: | Armoured vehicles Appendix 3: | Wheelchair accessible vehicles Appendix 4: | Other special purpose vehicles (including special group, multi-equipment carrier and trailer caravans) Appendix 5: | Mobile cranes Appendix 6: | Exceptional load transport vehicles Annex III | Procedures to be followed with respect to EU type-approval Appendix 1: | Standards with which the technical services referred to in Article 68 have to comply Appendix 2: | Procedure for the assessment of the technical services Annex IV | Conformity of production procedures Annex V | Small series and end-of-series limits Annex VI | List of parts or equipment that may pose a serious risk to the correct functioning of systems that are essential for the safety of the vehicle or its environmental performance, their performance requirements of such parts and equipment, the appropriate test procedures and marking and packaging provisions Annex VII | Regulatory acts for which a manufacturer may be designated as a technical service Appendix: | Designation of an in-house technical service of a manufacturer as technical service and subcontracting Annex VIII | Conditions for the use of virtual testing methods by a manufacturer or a technical service Appendix 1: | General conditions for the use of virtual testing methods Appendix 2: | Specific conditions for the use of virtual testing methods Appendix 3: | Validation process Annex IX | Procedures to be followed during multi-stage type-approval Appendix: | Model of the manufacturer's additional plate Annex X | Access to vehicle OBD information and vehicle repair and maintenance information Appendix 1: | Manufacturer's certificate on access to vehicle OBD information and vehicle repair and maintenance information Appendix 2: | Vehicle OBD information Annex XI | Correlation table

← LIST OF ANNEXES · All articles · ANNEX I →

Source: EUR-Lex (Cellar) · retrieved 2026-10-12 · Text as adopted (Official Journal); later amendments are not incorporated in this text.