(b)
The technical documentation for the purposes of conformity assessment pursuant to Article 4 shall contain the following elements: category of equipment: specification whether it is networked or non-networked equipment; for networked equipment, specification whether it is HiNA equipment, equipment with HiNA functionality, or other networked equipment; where no information is provided, the equipment is not considered HiNA equipment or equipment with HiNA functionality; for each off mode, standby mode and networked standby: the declared value of the power consumption in watts rounded to the first decimal place; the measurement method used; a description of how the equipment mode was selected or programmed; the sequence of events leading to the condition where the equipment automatically changes modes; any notes regarding the operation of the equipment, e.g. information on how the user switches the equipment into networked standby; if applicable, the default time needed for the equipment to reach the applicable low power mode or condition in minutes and rounded to the nearest minute; for networked equipment: the number and type of network ports and, with the exception of wireless network ports, where those ports are located on the equipment; in particular it shall be declared if the same physical network port accommodates two or more types of network ports; whether all network ports are deactivated before the equipment is placed on the market or put into service; whether there are ports relying on active wired connections for the intended use, and the procedure used for deactivating those ports; the power consumption of the equipment in networked standby if all wired network ports are connected and all wireless network ports are activated; guidance on how to activate and deactivate wireless network ports; for each type of network port: the period after which the power management function switches the equipment into networked standby; the remotely initiated trigger that is used to reactivate the equipment; the (maximum) performance specifications; the (maximum) power consumption of the equipment in networked standby into which the power management function will switch the equipment, if only that port is used for remote activation; the communication protocol used by the equipment; test conditions for measurements: ambient temperature; test voltage in V and frequency in Hz; total harmonic distortion of the electricity supply system; description of the instrumentation, set-up and circuits used for electrical testing; the equipment characteristics relevant for assessing conformity with the requirements set out in points 2(a), 2(b) and 2(c), as applicable, including the declared value of the time taken to automatically reach networked standby, standby mode or off mode, or another condition which does not exceed the applicable power consumption requirements for off mode or standby mode in minutes, rounded to the nearest minute. If applicable, a technical justification shall be provided that the requirements set out in point 2(a), 2(b), 2(c) and 2(d) are inappropriate for the intended use of equipment. The need to maintain one or more network connections or to wait for a remotely initiated trigger is not considered a technical justification for exemption from the requirements set out in point 2(b) in the case of equipment that is not defined as networked equipment by the manufacturer. For the requirements set out in point 2(c), the technical justification shall, in particular, provide evidence on why a main function needs to remain always active. In addition, where applicable, the packaging shall mention explicitly that: the equipment does not have a standby mode or other equivalent state in terms of energy efficiency requirements, power management function or the ability to deactivate wireless network connections mode; the power consumption of the equipment is likely to be higher than other equipment models meeting these functional requirements. the description of the equipment’s main functions.
← (4) · All articles · (1) →
Source: EUR-Lex (Cellar) · retrieved 2026-11-19 · Text as adopted (Official Journal); later amendments are not incorporated in this text.