2.

The model shall be considered to comply with the applicable requirements where all of the following conditions are fulfilled: the values given in the technical documentation pursuant to Annex IV, point 2, to Directive 2009/125/EC (declared values), and, where applicable, the values used to calculate those values, are not more favourable for the manufacturer, importer or authorised representative than the results of the corresponding measurements carried out pursuant to point (g) thereof; the declared values meet any requirements laid down in this Regulation, and any required product information published by the manufacturer, importer or authorised representative does not contain values that are more favourable for the manufacturer, importer or authorised representative than the declared values; when the Member State authorities check the unit of the model, it complies with the requirements, except for the requirements for which points (d), (e) and (f) apply; when the Member State authorities test the unit of the model, the determined values (the values of the relevant parameters as measured in testing and the values calculated from these measurements) comply with the respective verification tolerances as set out in Table 4; when the Member State authorities test five units of the model, the determined values (that is the values of the relevant parameters as measured in testing and the values calculated from those measurements) comply with the respective pass rate as given in Table 5; when the Member State authorities test the five units of the model, the arithmetic mean of the determined values (that is the values of the relevant parameters as measured in testing and the values calculated from these measurements) complies with the respective verification tolerances as given in Table 4.

← 1. · All articles · (a) →

Source: EUR-Lex (Cellar) · retrieved 2026-11-03 · Text as adopted (Official Journal); later amendments are not incorporated in this text.